Table of Contents
Advertisement
Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory 2
Removal tool
2
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
Removing the Unit
1
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2
Remove the screw (M4×8) on the back panel.
3
Insert the two removal tools deeply into the slots on each side,
as shown.
Catch
Lock
Screw (M4X8)
(commercially
available)
4
Lower the removal tool
toward the bottom, and pull
out the unit halfway whilst
pressing towards the inside.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
— 28 —
— 28 —
Be careful to avoid injury from the catch pins on the removal tool.
Accessory 2
Removal tool
Advertisement
Table of Contents
