Connecting Wires To Terminals - Kenwood DPX-7010MD Instruction Manual

Connecting Wires to Terminals

Rear left output (White)/
Non-fading left output (White)
Rear right output (Red)/
Non-fading right output (Red)
KENWOOD disc changer control input
NOTE
To connect the Disc changer,
consult your Disc changer manual.
To car light control switch
When using the optional power amplifier,
connect to its power control terminal.
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Ignition key
switch
Car fuse
box
(Main
fuse)
Battery
+ –
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Automatic illumination/Dimmer
control wire (Orange)
Power control wire
(Blue/White)
External amplifier control wire
(Pink / Black)
Motor antenna control wire
(Blue)
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse box
Ground wire (Black) - (To car chassis)
FM/AM antenna input
10
Fuse
(10A)
ILLUMI
Wiring harness
(Accessory#)
P.CONT
White/Black
EXT.
CONT CONT FRONT•L
Gray/Black
ANT
FRONT•R
CONT CONT
Green/Black
REAR•L
Purple/Black
REAR•R
2CAUTION
When only two speakers are being connected to the system, connect
the connectors either to both the front output terminals or to both the
rear output terminals (do not mix front and rear). For example, if you
connect the + connector of the left speaker to a front output
terminal, do not connect the - connector to a rear output terminal.
— 29 —
Front left output (White)
Front right output (Red)
To front left
–
speaker
+
White
–
To front right
speaker
+
Gray
–
To rear left
speaker
+
Green
–
To rear right
speaker
+
Purple