Linksys SPA2102-NA User Manual page 26

Phone Adapter with Router
Action Command
(press these
keys on the
telephone)
Check Firmware 150
Version
Check Primary DNS 160
Server IP Address
Check Internet Web 170
Server Port
Check Local IP 210
Address
Set Internet 101
Connection Type
Set Static IP Address 111
18
Interactive Voice Response Menu
Choices
Press 0 to use DHCP.
Press 1 to use a static IP
address.
Press 2 to use PPPoE.
Enter the IP address using
numbers on the telephone
keypad. Use the * (star)
key when entering a
decimal point.
Description
Hear the version number of the firmware
currently running on the Phone Adapter.
Hear the IP address of the primary DNS
(Domain Name Service) server.
Hear the port number of the Internet Web
server used for the Web-based Utility.
Hear the local IP address of the Phone
Adapter.
Select the type of Internet connection you are
using. Refer to the documentation supplied
by your Internet Service Provider (ISP).
First, set the Internet Connection Type to
static IP address; otherwise, you will hear,
"Invalid Option," if you try to set the static IP
address.
firmware: the programming code that
runs a networking device.
dhcp (dynamic host configuration
protocol): a protocol that lets one device
on a local network, known as a DHCP
server, assign temporary IP addresses to
the other network devices, typically
computers.
static ip address: a fixed address
assigned to a computer or device that is
connected to a network.
pppoe: a type of broadband connection
that provides authentication (username
and password) in addition to data
transport.
Chapter 5: Using the Interactive Voice Response Menu
Using the Interactive Voice Response Menu