Feature
Phone 1
Phone 2
Internet
System
Back Panel
Feature
Reset
Phone 1,
Phone 2 (Gray)
Ethernet (Yellow)
SPA122 Only
Internet (Blue)
Power
Cisco SPA100 Series Analog Telephone Adapters
Description
Steady green—On hook.
Slow flashing green—Off hook.
Off—Port not ready.
Flashing green—Transmitting or receiving data through
the WAN port.
Off—No link.
Steady green—System ready, IP address acquired.
Slow flashing green—Acquiring IP address. (By default,
uses DHCP.)
Fast flashing green—Upgrading firmware.
Off—No power or system can not boot up.
Description
Using a paperclip or similar object, press this button
briefly to restart the unit. Press and hold for 10
seconds to restore the factory default settings.
Connect to an analog phone, using an RJ-11 phone
cable.
Can be used to connect to a device on your network,
such as a computer, using an Ethernet cable.
Connect to a broadband network device (DSL or
cable modem) or a network router, using an Ethernet
cable.
Connect to a power source, using the provided
power adapter.
3