Edelbrock 5204 Installation Instructions

Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, contact our
Technical Hotline at: 1-800-416-8628, 7 am to 5 pm, Monday-Friday, Pacific Standard Time or e-mail us at
Edelbrock@Edelbrock.com.
Vehicle Applications:
Catalog #5204 - 1982-2002 Camaro/Firebird & 1978-1988 GM A/G-Body
Catalog #5205 - 1964-1972 GM A/G-Body
Tools and Supplies Required:
❑ Floorjack
❑ Jackstands
❑ Tire chocks
❑ Lug wrench
NOTE: Edelbrock Trailing Arm hardware kits are available - Hardware Kit #5215 fits 5201 & 5204; #5217 fits #5205
(Optional - stock hardware may be re-used if in satisfactory condition).
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
1. Place car on level surface and place tire chocks in front of and behind front tires (Fig. 1).
2. Support rear of the car on jack stands and remove the rear wheels.
3. Place a floor jack under the differential and lift up slightly to remove tension from the trailing arm bolts - make sure
not to lift the car off the jackstands (Fig. 2).
KEEP FLOOR JACK UNDER CAR DURING THE COMPLETE REMOVAL AND INSTALLATION PROCEDURE
CAUTION - DO NOT REMOVE BOTH TRAILING ARMS AT THE SAME TIME OR THE AXLE WILL ROTATE AND THE
TRAILING ARM INSTALLATION WILL BE MUCH MORE DIFFICULT.
©
2006 Edelbrock Corporation
Rev. 9/06 - DA/mc
❑ 18mm socket and combination wrench (3/4" for #5205 only)
❑ Torque wrench
❑ Blue Loctite™
❑ Grease gun
IMPORTANT NOTE:
result in poor performance and engine or vehicle damage.
REMOVAL OF STOCK TRAILING ARMS
Fig. 1
Edelbrock Lower Trailing Arms
Vehicle Applications: See Below

INSTALLATION INSTRUCTIONS

Page 1 of 2
Catalog #5204 & #5205
Fig. 2
Catalog #5204 & #5205
Brochure #63-5204