Surround Modes - B&K AVP3090 Owner's Manual

Surround mode explanation

SURROUND MODES

DOLBY SURROUND
3 STEREO
3 STEREO HALL
STEREO
STEREO F/R
STEREO HALL
DIRECT
DTS
† Output configurations for each mode are limited by the speaker setup in the SETUP
menu.
L The DTS mode is only a 5.1 channel surround setup. You must have all channels to
properly use this mode. Example: If you are missing the center channel speaker the
system will not send the information to the front left or right, the sound will simply be
lost.
The surround setup is for zone 1 only. Zone 2 does not require any setup procedure as
it is a stereo (left and right channel) zone only.
CHANNELS
ON † RANGE
LF,RF,C,LR,RR 0 - 15 ms
SUB
15 - 30 ms
LF,RF,C,SUB
LF,RF,C,LR,RR 0 - 15 ms
SUB
15 - 30 ms
LF,RF,SUB
LF,RF,LR,RR
SUB
LF,RF,LR,RR 0 - 15 ms
SUB
15 - 30 ms
LF,RF,SUB
LF,RF,C,LR,RR,
SUB
Page 21
DELAY
AC-3 Mode-All speakers are full
or range. Dolby Pro Logic- Rear left and
right are mono surround and sent
through the delay.
0 ms Rear left and right signals mixed with
front left and right.
Rear left and right are mono surround
or and sent through the delay.
0 ms Stereo listening mode.
0 ms Front left is sent to the rear left and
front right is sent to the rear right.
SUB is the front left and right signals
summed.
Same as 3 STEREO HALL with no
or center channel.
0 ms Direct mode is the same as Stereo
mode except the 2 channel output
signal is pre-processor for analog
sources. (True Stereo bypass if using
analog inputs)
L DTS Mode-All speakers are full
0 ms
range. You must have all speakers in
your system to properly use this
mode.
NOTES †