Inserting And Removing The Sd Memory Card; Direct Start-Up Into The Memory Viewer Mode - Sanyo PLC XU115 - XGA LCD Projector Function Manual

Memory viewer function

Inserting and removing the SD memory card

Insert the SD memory card into the card slot
on the back side of the projector as shown in
the figure below.

Direct start-up into the memory viewer mode

After inserting the SD memory card, the SD memory card indicator blinks, "Wired" or "Wireless" from
the input menu of the projector is automatically selected, the memory viewer start-up image appears
briefly and then an image stored in the SD memory card is displayed on the screen.
*Automatically, the same input of "Wired" or "Wireless" is selected as last time.
* If the image file is not available in the root directory of the SD memory card, the memory viewer
browser window appears.
* During operating the Network Viewer, the Network Capture or the Moderator functions, the direct
start-up into the memory viewer mode can not operate.
* When the projector is turned off and on while the SD memory card is left inside in the memory
viewer mode, the projector starts into the memory viewer mode and an image stored in the SD
memory card is displayed on the screen.
When you press AUTO SETUP/CANCEL button in the memory viewer mode, the memory viewer
browser window as shown on page 6 appears on the screen.
When you remove the SD memory card during operating the projector in the memory viewer mode,
the input source returns to the previous one selected just before inserting the SD memory card.
Note:
✐ During accessing to the SD memory card, do not turn off the power or eject the card because the
data in the card might get damaged. During accessing, the SD memory card indicator is blinking
✐ The SD memory card allows you to insert or remove regardless of the power status of the projector.
✐ The direct start-up into the memory viewer mode may not operate when the SD memory card is
inserted immediately after being removed.
✐ The Network Viewer and the Moderator functions are non-Mac-compliant.
4
Push the SD memor y card in the arrow
direction gently to remove. The card comes
out and you can remove it.
Insert a card with
cutting side up until
it clicks.
Push the card until
it clicks. The card
comes out.