When Room Temperature Is Low; Paper Setting With Or Without The Take-Up-Reel Unit - HP Designjet 10000s User Manual

104 inch

Hide thumbs Also See for Designjet 10000s:

Table of Contents

When room temperature is low

Always turn on the heater to keep air from the dryer at room temperature +10 to 20 °C. Raising the

temperature to a certain level is required to dry the printed paper. Room temperature should be kept at

20 °C or more to increase drying efficiency.

Paper settings with or without the take-up-reel unit are shown below.

●

With take-up-reel unit:

Determine the location relative to the dryer as shown in the figure below.

●

Without take-up-reel unit:

Pull out the paper through the legs of the dryer as shown in the figure below.

NOTE Avoid pulling out the paper too much as the printed surface may touch the dryer.

ENWW

Efficient use of the dryer

Table of Contents

Designjet high speed dryer