Connections - Panasonic 65PF9UK - TH - 65" Plasma Panel Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– AC cord fi xing
3
2
Note: The power plug in the illustration may not be the type fi tted to
your set.
– Cable fi xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note:
At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AC cord connection (see page 13)
Connect the AC cord plug to
1
the Plasma Display.
Fix the left side clamper.
2
1
Fix the right side clamper.
3
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
Pull
2
AUDIO R AUDIO
DVI-D IN COMPONENT/RGB IN
SLOT2
DVI-D IN COMPONENT/RGB IN
Terminals and Audio IN Terminals
(see page 12) (see page 12)
1
2
SPEAKERS
Terminals (L)
Close
Open
To loosen:
Push the catch
L
P /C /R P /C /B Y/G
R R B B
SLOT3 PC IN
From EXTERNAL
monitor terminal on
Computer (see page 10)
1
2
Push until the hook clicks.
2. Pull off.
1. Keep the knob pressed.
Pull
AUDIO
SERIAL
From SERIAL
Terminal on Computer
(see page 11)
9