In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).

•

Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust.

•

If an oven is installed beneath the hob, make sure that it is equipped with a cooling system.

•

In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.

•

To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.

•

Do not install the hob above a dishwasher or washing machine, to prevent the electronic circuits from coming into contact with steam or moisture and being damaged

as a result.

For electrical connection, use an H05RR-F cable as specified in the table below.

230 V ~ +

230-240 V ~ +

230 V 3 ~ +

400 V 3N ~ +

400 V 2N ~

Connect the yellow/green earth wire to the terminal with the symbol

This wire must be longer than the other wires.

Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself.

Secure the power cable with the cable clamp.

Close the cover (C) and screw it on the terminal block with the removed screw - point (1).

Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds.

If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an all-pole

disconnect switch with minimum contact gap of 3 mm.

3 x 4 mm

3 X 4 mm

(Australia only)

4 X 1.5 mm

5 X 1.5 mm

4 X 1.5 mm

400 V 3N ~

400 V 2N ~

GB16

230-240 V ~ (Australia only)

230 V ~