Adjusting Automatic Oiler; Equipment Check - Echo PPT-2100 Operator's Manual

18
IMPORTANT
Stored fuel ages. Do not mix more fuel than you expect to use in
thirty (30) days, ninety (90) days when a fuel stabilizer is added.
IMPORTANT
Stored two-stroke fuel may separate. ALWAYS shake fuel con-
tainer thoroughly before each use.
AUTOMATIC OILING SYSTEM
0
1. Turn oil fill cap 45
2. Fill with a quality, low viscosity, guide bar and saw chain oil.
IMPORTANT
To prevent plastic deterioration, do not use synthetics or silicones
based oil.
3. Set rate indicator (A) to center by turning adjustment wheel (B).
4. Adjust for minimum oil rate by turning adjustment wheel (B). (Very
little visible oil on the saw chain will provide sufficient lubrication).
NOTE
Proper oiling rate will use one reservoir of oil for each tank of gas.
IMPORTANT
Do not force adjustment wheel after indicator has reached the end
of travel window.

EQUIPMENT CHECK

Before operation a complete check of the unit must be performed;
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or
replace as needed.
• Inspect fuel lines, tank and area around carburetor for fuel leaks. DO
NOT operate unit if leaks are found.
• Check that the cutting attachment is firmly attached and the saw chain
is correctly tensioned on the guide bar. Dull, loose or damaged saw
chain should not be used. Refer to page 29 for correct Filing Saw
Chain procedures.
• Check that shoulder harness is adjusted for safe, comfortable opera-
tion. See figure at right for proper adjustment.
counter clockwise and lift to remove.
S M T W T F
1 2 3 4 5 6
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31
A
15 M
(50 ft.)
S
7
B