Chapter 2 Initial Switch Configuration; Preparing For Network Connections; Configuration Prerequisites - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Initial Switch Configuration
This chapter provides instructions for setting up the hardware, connecting to the console port, and
initially configuring the switch from the CLI.
This chapter includes the following sections:
•
•
•
•
•

Preparing for Network Connections

When preparing your site for network connections to the Cisco MDS 9000 switch, consider the
following:
•
•
•
Before installing a device, have all additional external equipment and cables available.

Configuration Prerequisites

Before you configure a switch in the Cisco MDS 9000 Family for the first time, make sure you have the
following information:
•
•
•
•
•
OL-7765-05
Preparing for Network Connections, page 2-1
Connecting the Console Port, page 2-2
Connecting the 10/100 Ethernet Management Port, page 2-4
Using the Switch Setup Utility, page 2-5
Verifying the Module Status, page 2-9
Cabling required for each interface type
Distance limitations for each signal type
Additional interface equipment needed
Administrator password.
Switch name—This name is also used as your switch prompt.
IP address for the switch's management interface.
Subnet mask for the switch's management interface.
IP address of the default gateway.
C H A P T E R
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
2
2-1