When The Engine Is Warm - Echo CS-8000 TYPE1-E Instruction Manual

Push
Throttle trigger
Start / Run
Starter handle
Unlock chain brake
Open choke
Unlock chain brake
Chain brake
Throttle latch
Throttle trigger lockout
Ignition switch
Choke control knob
WHEN THE ENGINE IS HARD TO
START
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Press throttle trigger lockout down while
grasping throttle trigger and push in throttle latch.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• When engine starts, immediately squeeze
throttle trigger, to release throttle latch, and pull
front hand guard towards the operator
immediately. (Chain brake unlocked position)
1. When using throttle latch for starting, keep
the brake in lock position.
2. After starting the engine, squeeze throttle
trigger slightly to release throttle latch and
pull front hand guard towards the operator
immediately.
(Chain brake unlocked position)
3. Do not increase engine speed while chain
brake is locked.
4. Use the chain brake only in starting or in
emergencies.
The chain will attempt to rotate when engine
is started with throttle latch engaged. After
engine starts, release throttle trigger to idle
engine, otherwise brake damage may occur.
Never use throttle latch for cutting. Use it
only when starting the engine.

WHEN THE ENGINE IS WARM

• Move chain brake lever fully forward to lock chain
brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but be sure to
push it back on first firing sound.
• After starting the engine, pull front hand guard
towards the operator immediately. (Chain brake
unlocked position)
15
CAUTION
CAUTION
CAUTION
CS-8000 TYPE1-E