Storage After Use; Technical Data - Echo CS-510 Instruction Manual

Inspect and adjust every part of the chain saw.
- Completely clean every part and repair if
necessary.
- Apply thin coating of oil on metal parts to
prevent rust.
Remove chain and guide bar, apply sufficient oil
coating and wrap them up in plastic sheet.
Drain fuel tank, pull starter slowly a few times to
drain fuel from carburettor.
Pour a small amount of clean motor oil into spark
plug hole, pull starter and crank the engine until
the TOP DEAD CENTER.
Store in a dry area, free from dust.
Dimension L x W x H
Masses Power head, dry
Engine Type
Displacement
Carburettor
Magneto
Spark plug
Starter
Power transmission
Fuel Mixture ratio
Tank capacity
Oil Bar and chain
Tank capacity
Guide bar and
saw chain
Lubrication
Standard
features
* Technical data subject to change without notice.

STORAGE AFTER USE

TECHNICAL DATA

CS - 510
mm 398 x252x 272 (15.7 in x 9.9 in x 10.7 in)
kg 4.9 (10.8 lb)
Without chain and guide bar
Air-cooled two-stroke single cylinder
mL (cm³) 49.3 (3.00 cu in)
Diaphragm type
Flywheel magneto : CDI system
CHAMPION CJ-6Y or NGK BPM 8Y
Recoil starter
Automatic centrifugal clutch
50 : 1 ratio with ECHO brand two-stroke oil.
89 octane unleaded. Do not use fuel containing
methyl alcohol, more than 10% ethyl alcohol or 15%
MTBE.
L 0.60 (20.3 US fl oz)
ECHO bar and chain oil (or motor oil)
L 0.28 (9.5 US fl oz)
See page 22 for Chain and Guide Bar
Combination
Adjustable automatic oil pump
Front hand guard, Rear hand guard
Anti-vibration, Spiked bumper
Throttle control lockout, Chain brake
Chain catcher, Spark arrestor muffler, Kick guard
25
WARNING
DO NOT STORE IN ENCLOSURE WHERE
FUEL FUMES MAY ACCUMULATE OR
REACH AN OPEN FLAME OR SPARK.
NOTE
For future reference, you should keep this
instruction manual.
CAUTION
Do not lend and rent your chain saw without the
Instruction manual, Safety manual and Kick-
guard instruction.
DANGER