Preparation For Use - Echo CS-510 Instruction Manual

Clutch cover
Adjusting screw
Proper tension

PREPARATION FOR USE

Bar hole
Improper tension
CAUTION
All adjustment, should be made cold.
Always wear gloves when working on chain.
MOUNTING GUIDE BAR AND
CHAIN
Unscrew two nuts and remove clutch cover.
Install the spiked bumper on the front of
machine. (Use two bolts 5 12)
Spiked bumper
Mount bar and slide toward clutch to make saw
chain installation easier.
Install saw chain as shown.
(Ensure cutters are pointing in the right direction)
Install the clutch cover tighten nuts finger tight.
Ensure that chain tension adjuster fits into bar
hole.
NOTE
Ensure that the chain is installed with the cutters
directed forward on the top of the bar.
ADJUSTMENT, CHAIN TENSION
Hold the bar nose up and turn the adjuster
clockwise until the chain fits snugly against the
underside of the bar.
Tighten both nuts with the bar nose held up.
Start the engine and run at low speed.
Stop and readjust if necessary.
8
Two bolts 5 12