Next Steps; Setting Quickloop Mode On Ports; Setting Up Speed Negotiation - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Quick Start Manual

Next Steps

Setting QuickLoop Mode on Ports

Setting Up Speed Negotiation

24
system configuration file, and
specified.
The password operand is only required if you are using FTP.
Note
5. Reboot the switch by entering the following command:
fastBoot
Specific tasks remain to be completed before the switch is fully operational
and manageable in your network with your equipment. These tasks and the
associated tools are described in the remaining documents shipped with the
product on the documentation CD-ROM. This section provides specific
guidance for completing tasks that many users may need to do.
The default configuration for a port is fabric mode. QuickLoop is used to
connect private hosts to private storage using the Fibre Channel network. A
QuickLoop zone, connecting two switches, may be used to expand the
number of private hosts and storage connected. An entire switch can be set
to operate in QuickLoop mode using the
port on a switch operating in Mixed mode can be set to or removed from
QuickLoop using the telnet commands
. See the QuickLoop User's Guide for more details.
qlPortDisable
The FC 16B ports can operate at three different speed levels: auto-sensing
mode, 1 Gbps mode, or 2 Gbps mode. Use the telnet command
to set the speed level for all ports in a switch. Use the
switchCfgSpeed
to set the speed level for a single port. Depending on your
portCfgSpeed
environment you may need to force a port to use a specific speed level.
Auto negotiation may not be supported by the device. Check the
configuration information for your network components for specific
requirements. See the Fabric OS Reference Manual for a detailed
command description.
is the password for the user ID
password
telnet command. A
qlEnable
qlPortEnable
and
Quick Start Guide