Kenmore 7817 - 20.6 cu. Ft. Top Freezer Refrigerator Use And Care Manual page 6

Refrigerator top mount
Table of Contents

Advertisement

To ConnectWater
Supply
LineTo
ice Maker
inlet Valve
1.
Disconnect
refrigerator from electric power source.
2.
Place end of water supply line into sink or bucket. Turn ON
water supply and flush supply line until water is clear. Turn
OFF water supply at shutoff valve.
3.
Unscrew plastic cap from water valve inlet and discard
cap.
4.
Slide brass compression
nut, then ferrule (sleeve) onto
water supply line, as shown.
5.
Push water supply line into water valve inlet as far as it
will go (1Ainch). Slide ferrule (sleeve) into valve inlet and
finger tighten compression
nut onto valve. Tighten another
half turn with a wrench; DO NOT over tighten.
6.
With steel clamp and screw, secure water supply line to
rear panel of refrigerator as shown.
7.
Coil excess water supply line (about 2Y2 turns) behind
refrigerator as shown and arrange coils so they do not
vibrate or wear against any other surface.
8.
Turn ON water supply at shutoff valve and tighten any
connections that leak.
9.
Reconnect refrigerator to electrical power source.
10. To turn ice maker on, lower wire signal arm (see ice
maker front cover for ON/OFF position of arm).
Before
Installing
The Water
Supply
Line, You Will Need
Basic Tools: adjustable wrench, flat-blade screwdriver,
and Phillips
TM
screwdriver
Access to a household cold water line with water pressure
between 30 and 100 psi.
A water supply line made of 1Ainch (6.4 mm) OD, copper
tubing. To determine the length of copper tubing needed,
you will need to measure the distance from the ice maker
inlet valve at the back of the refrigerator to your cold water
pipe. Then add approximately 7 feet (2.1 meters), so the
refrigerator can be moved out for cleaning (as shown).
A shutoff valve to connect the water supply line to your
household water system. DO NOT use a self-piercing type
shutoff valve.
A compression
nut and ferrule (sleeve) for connecting the
water supply line to the ice maker inlet valve.
,_
_
Steel
\Plastic
Water Tubing
_
Clamp
\\
to ceMaker/
!
u[I
\_--Fill
Tube _
I_,
I
Brass
\_
/
W
I Compression
I'
)
Ferrule
_
_ ,_
Copper
water,,ne
/((
etorvs,vo
er
ater
I ne
Copp
w
"
from
househo
d water suppy
/_
(Include
enough
tubing
in loop to allow
moving
refrigerator
oat for cJeaning.)
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

253 series970 series

Table of Contents