Table of Contents
Advertisement
3.2 Mounting
For information on mounting, see the "FUJITSU 2.5-INCH HDD
INTEGRATION GUIDANCE (C141-E144)."
(1) Orientation
The disk drives can be mounted in any direction.
(2) Frame
The MR head bias of the HDD disk enclosure (DE) is zero. The mounting frame
is connected to Signal Ground (SG).
Use M3 screw for the mounting screw and the screw length should
satisfy the specification in Figure 3.2.
The tightening torque must be 0.49N • m (5kgf • cm).
When attaching the HDD to the system frame, do not allow the
system frame to touch parts (cover and base) other than parts to
which the HDD is attached.
(3) Limitation of mounting
Note) These dimensions are recommended values; if it is not possible to satisfy
them, contact us.
Bottom surface mounting
2
A
Frame of system
cabinet
3.0 or less
Details of A
C141-E244
IMPORTANT
2.5
DE
Screw
3.0 or less
Figure 3.2 Mounting frame structure
Side surface
2.5
mounting
2.5
PCA
Frame of system
cabinet
Screw
3.2 Mounting
2.5
B
3-3
Advertisement
Table of Contents
