Installation; Preparation; Warning - Chamberlain LiftMaster SL930 User Manual

PREPARATION

TEST OPERATOR
Remove the gate operator from its package and make sure that all
parts are included. Refer to the Carton Inventory and Repair
Parts. If any parts appear to be missing, contact dealer
Temporarily plug the operator into 115 Volt outlet or extension
cord (Figure 1).
Before beginning installation, test the gate operator by running
the operator back and forth 2 or 3 times. If the gate operator
appears to have any shipping damage, contact a dealer.
SET REMOTE
The operator may be run back and forth by momentarily touching
the open input terminals together. The terminals can be touched
together with a short length of wire, paper clip or needle nose
pliers. With full systems capability circuit board, the open input
terminals are 5 and 6 (Figure 2).
Disconnect power when finished!
GATE PREPARATION
The tail end of the gate should extend approximately 24" beyond
the edge of the driveway. If this is not the case, an extension tail
will need to be added to the gate. This will give room for the gate
operator. Make the extension tail 24" x 24" (Figure 3). If the gate
has not yet been fabricated, add 24" to the length of the gate.
I N S T A L L A T I O N
.
To prevent possible SERIOUS INJURY or DEATH:
• DO NOT connect electric power until instructed to do so.
CAUTION
Figure 1
Power
Cord
AVERTISSEMENT
Extension
Cord
ATTENTION
Figure 2
Touch Open Terminals Together
Full Systems Board (5 & 6)
Push Remote
Control
Figure 3
ADVERTENCIA
24"
PRECAUCIÓN
24"
9

WARNING

WARNING
OR
Extension Tail