Assembling The Remote Control And Mounting The Cradle - Hunter 21894 Owner's Manual And Installation Manual

8 • Assembling the Remote Control and Mounting the Cradle (Continued)
Setting the DIP switches
You will only have to change the DIP switch settings in the remote if you are using more than
one remote controlled fan in the same area and want to control them separately. You may
want to label your remotes to ensure you do not mix them up.
1. At the circuit breaker or fuse box, turn the power off for the fan you want to change. Do
not turn the power off at the circuit breaker for the previously installed fan, as you may
inadvertently change the DIP switch code settings for it as well.
2. Slide the cover off the back of the remote and remove the battery. The battery must be
removed when changing DIP switch settings. Refer to Step 8-1.
3. Change the DIP switch settings, so that they are different from the previously installed
fan.
4. Replace the battery and cover.
5. At the circuit breaker or fuse box, turn the power back on for the fan whose settings you
are changing.
6. Within 20 seconds of restoring power, push the 3 (high), 2 (medium), and 1 (low) buttons
(in that order) on the remote.
Note: The receiver (built into the fan) has a memory function that retains the last DIP
switch code setting. The setting will not change in the event of power failure or if the
power to the fan is inadvertently shut off.
45003-01 • 07/12/2011 • Hunter Fan Company
16