Hunter 21711 Owners And Installation Manual page 16

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14 . To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the red wire .
7-15 . Disconnect the plug connectors between the two white
wires .
7-16 . Uninstall the connector and washer from the end of the
light fixture inside the lower switch housing .
7-17 . Unscrew the threaded rod of the light fixture from the lower
switch housing .
7-18 . Remove the light fixture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing .
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole .
7-19 . Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing .
7-20 . Install the switch housing cap and plug button to the lower
switch housing .
7-21 . Once you have uninstalled the light fixture, continue
with step 7-6 .
Male Dummy
Female Dummy
Terminal
Terminal
16
45046-01 • 01/13/11 • Hunter Fan Company
Threaded Rod
Steps 7-16 – 7-18
Cap
Plug Button
Lower Switch
Housing
Step 7-20