Table of Contents
Advertisement
Troubleshooting
Display
Turn off the machine with the main power switch and then turn it on again to clear the error message from the display.
Problem
The dishes are not clean.
Spots or films on the dishes.
The dishes have a sticky white/blue film.
Spots on stainless steel or silver.
26
Type of fault
Overfilling
Water outlet fault
Water inlet fault
Inlet valve leakage
Possible causes
The spray arms do not rotate.
Detergent is too old. Detergent is a per-
ishable product.
Incorrect detergent dosage.
Dishwashing program too weak.
Dishes loaded incorrectly.
Glasses and cups have toppled over
during the program.
The filter is not correctly fitted.
Incorrect rinse aid dosage setting.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired,
only prevented.
Rinse aid dosage setting too high.
Some types of food, such as mustard,
mayonnaise, lemon, vinegar, salt, and
dressings, can cause spots on stainless
steel if left for too long.
All stainless steel can cause spots on
silver if they come into contact during
dishwashing. Aluminum can also cause
spots on dishes.
Customer Care Center
Action
Call the Customer Care Center.
See "Water remains in the dishwasher above
the filters" in the table below.
Check that the water supply valve is on.
Turn off the water supply valve and call the
Customer Care Center.
1-800-898-1879
Action
Remove the arms and clean them.
Check that the dishes are not blocking
the spray arms.
Avoid large packages.
Dose according to water hardness. Far
too much or far too little detergent can
result in poor dishwashing results.
Select a higher temperature or a more
powerful program.
Do not cover dishes with large bowls or
lids. Avoid placing very tall glasses in
the corners of the baskets.
Load the dishes securely.
Screw the filter firmly into place. See the
section Care and maintenance instruc-
tions.
See the sections Rinse aid and Settings.
Wash crystal at a low temperature and
with a conservative amount of detergent.
Contact the detergent manufacturer.
Reduce the amount. See the sections
Rinse aid and Settings. If you have very
soft water, you may want to dilute the
rinse aid 50:50 with water.
Rinse off these types of food if not
starting the dishwasher immediately. Or
why not run the Rinse & Hold program?
Silver and stainless steel items should
not come into contact during dishwash-
ing.
Advertisement
Table of Contents
