Advertisement
DIMENSIONAL DRAWINGS
DIMENSIONAL DRAWING
MOUNTING POINT, 3/8"-16 THREADED HOLE
LA215
ALL DIMENSIONS IN INCHES UNLESS OTHERWISE SPECIFIED.
CABINET SYMETRICAL ABOUT ITS CENTERLINES.
CENTER OF GRAVITY.
RUBBER FOOT.
(6.25)
18.50
29.75
30.00
9.50
10.13
FRONT
(14.56)
5.50
3.00
25.63
6.75
12.98
TOP
2.06
LEFT SIDE
510183 EXP 4/1/97 SHB
Acoustic Performance Partnership
One Main Street, Whitinsville MA, 01588 USA • Phone 508/234-6158 • Toll Free 800/992-5013 • Fax 508/234-8251 • Web http://www.eaw.com • email info@eaw.com
(14.16)
5.08
2.25
6.38
14.88
BACK
RIGHT SIDE
4.50
6.75
8.78
5.81
"TOP HAT"
POLE SOCKET
35
(18.42)
(21.23)
BOTTOM
Eastern Acoustic Works
SPECIFICATIONS LA215
A & E SPECIFICATIONS
The two-way full range loudspeaker systems shall incorpo-
rate a 15-in LF transducer and a 2-in exit/3-in voice coil
compression driver HF transducer.
The LF driver shall be mounted in a vented enclosure tuned
for optimum low frequency response. The HF driver shall be
loaded on an axis-symmetrical wave guide plate with a nomi-
nal coverage pattern of 90 (conical). An internal passive
27.69
filter network shall provide fourth order acoustical crossover
and system equalization.
System frequency response shall vary no more than 3 dB
from 69 Hz to 18 kHz measured on axis. The loudspeaker
shall produce a Sound Pressure Level (SPL) of 97 dB SPL on
2.80
axis at 1 meter with a power input of 1 Watt, and shall be
capable of producing a peak output of 130.8 SPL on axis at
1 meter. The loudspeaker shall handle 600 Watts of amplifier
power (AES Standard) and shall have a nominal impedance
19.50
of 8 Ohms.
The loudspeaker enclosure shall be irregularly pentagonal in
shape. Rubber footpads shall be provided on one side and
one end. It shall be constructed of 1/2-in thickness void-
free cross-grain-laminated Baltic birch plywood and shall
employ extensive internal bracing. It shall be finished in
black catalyzed polyurethane. Input connectors shall be dual
Neutrik NL4 Speakon. The following mounting/suspension
hardware shall be provided: three 3-position flytracks with
integral 3/8"-16 threaded mounting points (2 top, 1 rear),
six 3/8"-16 threaded mounting points (1 top, 1 rear, 2 each
on two sides) and a recessed cup to accept a standmount
pole. The front of the loudspeaker shall be covered with a
vinyl coated perforated steel grille.
The two-way full range loudspeaker shall be the EAW model
LA215.
LA215
Advertisement
