Lenovo 7099B8U Hardware Maintenance Manual page 117

2. Remove the computer cover. See "Removing the computer cover" on page 101.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 102.
4. Pivot the drive bay assembly upward, remove the four screws that secure the heat sink fan duct, and
then lift the heat sink fan duct up to remove it from the chassis.
Figure 51. Removing the heat sink fan duct
5. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 99.
6. Remove the four screws that secure the heat sink and fan assembly in the following sequence:
Note: Carefully remove the four screws from the system board to avoid any possible damage. The four
screws are integrated parts of the heat sink and fan assembly and they cannot be removed from the
heat sink and fan assembly.
a. Loosen screw 1 , then completely remove screw
remove screw 1
assembly.
2
b. Loosen screw , then completely remove screw
remove screw 2
assembly.
from the system board, as shown in Screws that secure the heat sink and fan
from the system board, as shown in Screws that secure the heat sink and fan
Chapter 9
3 from the system board, and then completely
4
from the system board, and then completely
.
Replacing FRUs (Machine Types: 0889, 5023, and 7844.)
111