Sony SDX-800V Product Specifications Manual page 149

5.25" model
Hide thumbs Also See for SDX-800V:
Table of Contents

Advertisement

REQUEST SENSE
03h
00
02
0C
00
11
00
11
08
14
03
15
02
27
04
30
00
30
02
30
07
31
00
33
00
3B 08
50
00
52
00
70
NN
83
03
SONY AIT-3Ex drive SDX-800V series Ver.1.1
MEDIUM ERROR. Indicates that the current command or a previously acknowledged
write-type operation terminated with a non-recovered error condition that was probably
caused by a flaw in the medium, an error in the recorded data or the cleanliness of the
head. This sense key may also be returned if the drive is unable to distinguish between
a flaw in the medium and a specific hardware failure (sense key 4h). This condition is
also marked by the Valid bit being set, indicating that the information bytes contain
residue information.
END-OF-PARTITION / MEDIUM DETECTED
WRITE ERROR – The Read-After-Write Retry limit was exceeded during Write.
Probably caused by a flaw in the media.
UNRECOVERED READ ERROR - C1, C2 & C3 Error Correction could not correct a
Read Error. Probably caused by a flaw in the media.
INCOMPLETE BLOCK READ - The drive could not read the AITFormat Group
containing the requested block. Could be caused by head clogging or media damage.
END-OF-DATA NOT FOUND – While Reading a AIT format tape, the drive
encountered blank (unformatted) media during a Read operation. This error could be
caused by serious head clogging.
POSITIONING ERROR DETECTED BY READ OF MEDIUM - Cannot find destination
Group during Space operation.
APPEND POSITION ERROR
INCOMPATIBLE MEDIUM INSTALLED - Format violation.
Possible that the Sub-Area cannot be read.
CANNOT READ MEDIUM, INCOMPATIBLE FORMAT - Format violation,
non-AIT-3Ex Format.
CLEANING FAILURE
MEDIUM FORMAT CORRUPTED - AIT format Group GIT, BAT, or Sub-Codes do not
match or are improper.
TAPE LENGTH ERROR - Attempting to select partition 1 on a single tape. Requested
partition size in MODE SELECT -
Medium Partitions Parameter page is too large (exceeds tape length) or too small (0<
requested partition size in frames < 2541).
REPOSITION ERROR - Position lost during Read, Verify, Write, Space, Locate, Seek
or Select Partition operation.
WRITE APPEND ERROR - Cannot find the last frame of the Group and therefore,
cannot append.
CARTRIDGE FAULT
DECOMPRESSION EXCEPTION SHORT ALGORITHM ID OF NN - ALGORITHM ID
<= 255
MIC Checksum Error
6.Command Specification
6-91

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdx-800v/r

Table of Contents