Selecting Video Input Connectors; Adjusting The Tilt - HP XP598AA#ABA User Manual

When the monitor is powered on, a Monitor Status message is displayed for five seconds and the
power source LED on the rear of the monitor is green. The message shows which input is the current
active signal, the status of the auto-switch source setting (On or Off), the default source signal, the
current preset display resolution, and the recommended preset display resolution.

Selecting Video Input Connectors

The input connectors are:
●
VGA (analog)
●
DVI-D connector (digital) select models
●
HDMI connector (digital) select models
The monitor automatically scans the signal inputs for an active input and uses that input for the
display. If two inputs are active, the monitor will display the default input source. If the default source
is not an active input, then the monitor will display the other input if it is active. You can change the
default source in the OSD by pressing the front-panel Menu button and selecting Source Control >
Default Source.

Adjusting The Tilt

For optimal viewing, adjust the screen tilt to your own preference, as follows:
CAUTION:
changing the tilt.
1. Face the front of the monitor and hold the base so that you do not topple the monitor while
changing the tilt.
2. Adjust the tilt by moving the top edge of the monitor either toward or away from you, without
touching the screen.
Figure 3-8
ENWW
To avoid breakage or other damage, avoid applying pressure to the LCD screen while
Tilt Adjustment
Selecting Video Input Connectors 13