Menu De Configuracion - Coby DP700 Instruction Manual

Configuraci6n
Usted puede seleccionar el menu de configuraci6n en el menu principal.
0
mantenge pulsado al
bol6n MENU
para
entrar en al menu de configuraci6n.
Del menu de configuracl6n
Zoom
Intervalo
detiempo
Efeclo de
transicion
Escriba
Ampliar imagenes. Mantenga pulsado el bot6n MENU
para entrar en el menu de configuraci6n. establecer la
opci6n de ZOOM como en, a continuaci6n, pulse el
bot6n MENU de nuevo para salir del menu de configu­
raci6n, ahora usted puede pulsar repetldamenle el bot6n
ENTRAR
Establezca el intervalo de time.Enter SlideShow esta
opci6n, pulse el baton arriba
I
abajo para ajustar el
intervalo de tiempo.
Eslablecer el efecto de Iranslclon. Escriba esta opcl6n,
pulse el bot6n arriba I abajo para ajustar el efeoto de
translci6n.
Coloque
Is
cinta muestra de las imagenes como fondo de
escritorio de coincidencias y de pantalla completa.
automatica de denim I
' = J
5Se9
Azar
~
de
Isle
Fuera
0
0
0
Ingles
12. Grounding or Polarization: This product may be equipped with a
alternating-current line plug that has one blade wider than the other. This plug
will only fit into the power outlet in one direction. This is a safety feature. If you
are unable to insert the plug fully into the outlet, try reversing the direction of
the plug. If the plug should still fail to fit, contact an electrician to replace the
obsolete outlet. Do not defeallhe safely purpose of the polarized plug.
13. Power-Cord Protection: Power supply cords should be routed so thallhey are
not likely to be walked on or pinched by Items placed upon or against them,
paying particular attention to cords at plugs, convenience receptacles, and at
the point which they exit from the product.
14. Protective Attachment Plug: The product may be equipped with an attach­
ment plug with overload protection. This is a safety feature. See the operating
instructions for replacement or directions to reset the protective device. If
replacement of the plug is required, be sure the service technician has used
a replacement plug that has the same overload protection as the original plug
as specified by the manufacturer.
15. Outdoor Antenna Grounding: If an outside antenna is connected to the prod­
uct, be sure the antenna system is grounded so as to provide some protection
against voltage surges and built-up static charges. Article 810 of the National
Electrical Code, ANS/NFPA 70 provides Information with regard to proper
grounding of the mast and supporting structure, grounding of the lead-in wire
to an antenna-discharge unit, size of grounding conductors, location of an­
tenna-discharge unit, connection to grounding electrodes, and requirements
for the grounding electrode (see figure).
Antenna Lead-In Wire
Ground Clamp
Electric Service Equipment
Antenna Discharge Unit (NEC Section 810-20)
Grounding Conductors (NEC Section 810-21)
Ground Clamps
r.::;::;._...........
Power Service Grounding Electrode System
(NEe Art 250, Part H)
"