Table of Contents
Advertisement
Figure 21. Accessing the microprocessor
5. Lift the microprocessor straight up and out of the microprocessor socket, as shown in Figure 22
"Removing the microprocessor" on page 28.
Notes:
a. Your microprocessor and socket might look different from the one illustrated.
b. Note the orientation of the microprocessor in the socket. You can look for the small triangle
one corner of the microprocessor. This is important when installing the new microprocessor on
the system board.
c. Touch only the edges of the microprocessor. Do not touch the gold contacts on the bottom.
d. Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be
kept as clean as possible.
.
Chapter 2
Installing or replacing hardware
1
on
27
Advertisement
Table of Contents
