Epson Equity II Product Support Bulletin page 67

E P S O N
EPSON AMERICA INC.
SERVICE DEPARTMENT
PRODUCT
DATE: 3/16/87
SUBJECT: EQUITY
We would like to make you aware of a couple of different problems
caused by improperly set dip switches on the Equity II computer.
Some customers
running properly
BIOS and MS-DOS.
The cause of
co-processor
switched "OFF"
should have been in the "ON"
correctly and
This may also affect the
although we have not had any other reports.
Another problem
Equity II the system displayed Drive D: instead of Drive C:,
The problem was that the person who installed the hard disk drive
forgot to reconfigure
question has come up quite a few times.
SUPPORT
II PROBLEMS
have complained
on the Equity
the problems
switch (S1-2) was
without a
rebooting the
operation
was that
the dip
***** CHECK
DUE TO IMPROPER
about Lotus
II with the
was determined
in
the wrong
co-processor chip
position. After
system the software
of other
after installing a hard drive in an
switches
for 1
THOSE DIP SWITCHES!!
BULLETIN
S-0007
NUMBER:
DIPSWITCH SETTINGS
123 version 2.0 not
latest version
to be that
position. It was
installed when
setting the switch
ran normally.
software packages
floppy drive.
*****
Page 1 of 1
ROM
the
it
This