10 Operating Instructions and Installation
4. Enter button / Source button
Activates a highlighted menu item. /
Push the 'SOURCE', then selects the video signal
while the OSD is off. (When the source button is
pressed to change the input mode, a message
appears in the left upper side of the screen
displaying the current mode -- analog or digital
input signal.)
Note : If you select the digital mode, you must con-
nect your monitor to the graphic card's port using
the DVI cable.
10-2 Rear
(The configuration at the back of the monitor may vary from product to product.)
10-2
5. Auto button
When the 'AUTO' button is pressed, the Auto
Adjustment screen appears as shown in the ani-
mated screen on the center. Auto adjustment
allows the monitor to self-adjust to the incoming
video signal. The values of fine, coarse and posi-
tion are adjusted automatically. (Available in ana-
log mode only)
6. Power button
Use this button for turn the monitor on and off.
1. POWER S/W : Switch the monitor on and off.
2. POWER IN : Power cord, plugs into monitor and wall
receptacle.