Custom Setup; Audio Setup - Sony DVP-SR160 Reference Manual

CUSTOM SETUP

AUTO STANDBY: Sets the Auto Standby
setting on or off. If you select "ON," the player
enters standby mode when left in stop mode for
more than 30 minutes.
AUTO PLAY: When set to "ON," the player
automatically starts playback when the player is
turned on by a timer (not supplied).
PAUSE MODE: Selects the picture in pause
mode. Normally select "AUTO." When the
picture is output in high resolution, set to
"FRAME." (DVD only)
TRACK SELECTION: Gives the sound track
which contains the highest number of channels
priority when you play a DVD VIDEO on
which multiple audio formats (PCM, MPEG
audio, DTS, or Dolby Digital format) are
recorded. If you select "AUTO," priority is
given. (DVD VIDEO only)
MULTI-DISC RESUME: Switches the Multi-
disc Resume setting on or off. Resume playback
can be stored in memory for up to 6 different
DVD VIDEOs/VIDEO CDs. If you start the
settings again, the resume point is cleared.
(DVD VIDEO/VIDEO CD only)

AUDIO SETUP

AUDIO DRC (Dynamic Range Control)*
Set according the surrounding environment. Set
to "TV MODE" when the smallest sounds are
indiscernible, or set to "WIDE RANGE" when
the listening environment is good, for example,
in a home movie theatre.
2
DOWNMIX* : Switches the method for
mixing down to 2 channels when you play a
DVD which has rear sound elements (channels),
or is recorded in Dolby Digital format.
Normally select "DOLBY SURROUND."
DIGITAL OUT: Selects if audio signals are
output via the DIGITAL OUT (COAXIAL)
jack. When you select "ON," set also the
following "DOLBY DIGITAL," "MPEG,"
"DTS," or "48kHz/96kHz PCM."
DOLBY DIGITAL: Selects the type of Dolby
Digital signal. Set to "D-PCM" when the player
is connected to an audio component without a
built-in Dolby Digital decoder.
MPEG: Selects the type of MPEG audio signal.
Set to "MPEG" when the player is connected to
an audio component with a built-in MPEG
decoder.
DTS: Selects the type of DTS audio signal. Set
to "ON" when you play a DVD VIDEO with
DTS sound tracks. Do not set to "ON" when
you connect the player to an audio component
without a DTS decoder.
48kHz/96kHz PCM: Selects the sampling
frequency of the digital audio output signal.
(DVD VIDEO only)
1
When you select "OTHERS t," select and
*
enter a language code. See "LANGUAGE
CODE LIST" at the end of this manual.
2
* This function affects the output from the
following jacks:
– DIGITAL OUT (COAXIAL) jack only when
"DOLBY DIGITAL" is set to "D-PCM."
– LINE (RGB)-TV jack.
2
:
7