Sharp Aquos LC-60LE745U Operation Manual page 23

Watching TV
CH Search (Channel search)
Channel auto search makes the TV look for all
channels viewable in the set area.
8
When "Air" is selected in Antenna setting:
Press c / d to select "Start", and then press
ENTER.
Start
When "Cable" is selected in Antenna setting:
1 Press a / b to select "Analog & Digital Search
Start" to search both analog and digital
broadcasts, or to select "Analog Search Start"
to search only analog broadcasts, and then
press ENTER.
Analog & Digital Search Start
Analog Search Start
• The Channel search will start automatically.
• To exit the Channel search screen, select "Cancel",
and then press ENTER.
2 The Channel search results may include
scrambled channels or channels that are not
viewable in the set area. Press c / d to select
"Yes", and then press ENTER to remove
scrambled channels.
Yes
Cancel
Cancel
No
Network
When you connect to the Internet on the TV, select the
desired connection method and follow the instructions
shown on the display.
• Wireless LAN connection is possible only when the WPS
(push button) method is used. If any other method is used,
make settings by Initial Setup > Internet Setup > Network
Setup. (See page 67.)
Press c / d to select "Yes", and then press
9
ENTER.
Yes
Press a / b to select "Wired" or "Wireless", and
10
then press ENTER.
Wired
Wireless
Connection using an ETHERNET cable:
1 Select "Wired" and press ENTER.
2 Confi rm that the TV is properly connected
with the router, and then press "Next". Follow
the instructions on the display to perform the
connection test.
Wireless LAN connection by the WPS method:
1 Select "Wireless" and press ENTER.
2 Follow the instructions on the display, and
fi nalize the connection after testing its viability.
• When you change the network settings, refer to Initial
Setup > Internet Setup > Network Setup. (See page 67.)
No
21