Error Message List - Sharp XE-A507 User Manual

Error Message List

If an error message appears, refer to the table below and solve the problem.
N o t e • If the [OK] button is displayed in the message box, click [OK] to close the message box.
• If the [Yes] or [No] button in the message box, click either of them to close the message box.
Error Message
PC-LINK has already started.
XML file is broken.
PC-LINK operates in the initial state.
Already same DEPT code exists.
Already same PLU/UPC code exists.
Already same CLERK code exists.
Drive is not specified.
Input the folder path.
The path doesn't exist.
The file is not found.
The file doesn't exist, or path is illegal.
The file is not bitmap file.
The file is not supported size.
The file format is not supported color.
Picture convert DLL is not found.
Invalid character is used.
Solution
Customer Support Tool has already started. You cannot start
Customer Support Tool when it is already operating.
Customer Support Tool failed to read a data file normally because it
was destroyed or did not exist. Instead of data that was not read, the
default data was set.
That code is already used. To create a new code, input a code that
does not exist in the list.
To select a code, click the row in the list or change the code with the
[<] or [>] button in the left lower part of the screen.
That code is already used. To create a new code, input a code that
does not exist in the list.
To select a code, click the row in the list or change the code with the
[<] or [>] button in the left lower part of the screen.
That code is already used. To create a new code, input a code that
does not exist in the list.
To select a code, click the row in the list or change the code with the
[<] or [>] button in the left lower part of the screen.
Click the name of the displayed drive, and then [OK].
Input the correct folder name in the data folder.
The path (drive or folder) you have defined does not exist. Input the
correct path.
The file you have defined does not exist. Input the correct filename.
The file you have defined is not a bitmap file. Use a bitmap file.
The size of the file you have defined is not appropriate. Use a bitmap
file with 360-pixel width and 130-pixel height.
The bitmap file you have defined is full-colored. Use a monochrome
bitmap file.
A program file for bitmap conversion is not found.
If you have deleted pictcnv.dll by mistake, you have to download and
install it again.
You are using characters that cannot be used as a filename.
Do not use \ / : * ? " < > |.
40