Making Minor Adjustments Between; Installing The Water Dispenser Line - Samsung RF323TEDBSR User Manual

MAKING MINOR
ADJUSTMENTS BETWEEN
DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Fixed part Fixed part
The left door is fi xed. To make minor
adjustments between doors, adjust only
the right door.
1. Pull out the freezer drawer (
lower hinge ( 2 ).
2. Insert the supplied allen wrench (3/16") (
into the shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning the hex wrench (
clockwise ( ) or counter clockwise (
DOWN DOWN
When you turn the hex wrench counter-
clockwise ( ), the door will move up.
2
3
4
1
4. After adjusting the doors, insert the supplied
fastener ( 6 ) using a pliers ( 5 ) in the gap
between the hinge-grommet ( 7 ) and the lower
hinge ( 8 ). The number of fasteners you'll need
to insert depends on the gap.
10_ setting up
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862Kpa) is required.
If the refrigerator is installed in an area with low
Adjustment Adjustment
water pressure (below 20psi), you can install
part part
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly fi lled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
1 ) to reveal the
3 )
3 )
UP UP
).
Connecting to the water supply line
1. First, shut off the main water
supply.
3
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
3. Connect the water line installation kit to the
shut off valve.
2 fastener are enclosed with the refrigerator.
The thickness of each fastener is 0.04".
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.
Cold water line Cold water line
Pipe clamp Pipe clamp
Shut off valve Shut off valve