Samsung WF461ABW User Manual page 30

troubleshooting
ERROR IMAGE
nF
nF1
Sr
OE
E2
tE
3E
AE
AE3
SF
SUdS
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
30_ Troubleshooting
WF431ABP-03016A-07_EN_v1.indd Sec6:30 WF431ABP-03016A-07_EN_v1.indd Sec6:30
MEANING
Your washer has tried to fill but was
unsuccessful.
Check if the hot water supply hose is
connected.
The hot/cold water hose connection is
not correct.
Problem with control.
Water detected over the safe water
level.
Jammed key.
Temperature sensor problem.
Motor problem.
Communication error between SUB
PBA and MAIN PBA
This is displayed when an error occurs
while communicating with the DR ready
modem.
System error
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
into the operation.
When it finishes washing, "End" and
"SUdS" codes will blink in turn.
SOLUTION
Make sure the water faucets are open all
the way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then
please remove the device and connect
the water hoses directly to the unit.
You must connect the hot water supply
hose because hot water is supplied by
the Auto Temperature Control (A.T.C.)
function if the temperature of the cold
water is lower than 59°F.
Please connect the hot/cold water hose
connection correctly.
Call for service.
Call for service
Call for service
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Call for service
Call for service
Call for service
Reduce the amount of detergent you
use.
2012-05-09 2012-05-09 2:17:27 2:17:27