Get Started; Connect The Base Station And Charger; Install The Handset - Philips SE8881B/38 User Manual

3 Get started

Caution
•
Make sure that you have read the safety instructions in
the "Important" section before you connect and install
your handset.
Connect the base station and
charger
Warning
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or underside of the phone.
•
Use only the supplied power adapter to charge the
batteries.
Note
•
If you subscribe to the digital subscriber line (DSL) high
speed internet service through your telephone line,
make sure that you install a DSL filter between the
telephone line cord and the power socket. The filter
prevents noise and caller ID problems caused by DSL
interference. For further information about DSL filters,
contact your DSL service provider.
•
The type plate is located on the bottom of the base
station.
1
Connect each end of the power adapter
to:
• the DC jack at the bottom of the
base station;
• the power socket on the wall.
2
Connect each end of the line cord to:
• the telephone socket at the bottom
of the base station;
• the telephone socket on the wall.
3
Connect each end of the power adapter
to (for multi-handset versions only):
EN
14
• the DC jack at the bottom of the
extra handset charger.
• the power socket on the wall.
4
For mobile phones with micro USB
charging, connect the micro USB cable plug
to the micro USB socket of the mobile
phone.
5
For iPhone users, connect the plug of your
USB charging cable (not supplied) to the
USB socket at the bottom of SE888.

Install the handset

The batteries are pre-installed in the handset.
Pull off the battery tape from the battery door
before charging.