Base station Charger Handset CD rom Power adapter Line cord Quick start guide Guarantee Note In multi-handset packs, there are additional handsets, chargers and power adapters. In some countries, you have to connect the line adapter to the line cord, then plug the line cord to the telephone socket.
Get started Connect the base station and charger Power Telephone socket socket Telephone base station 1 Connect each end of the power adapter to: Power • the DC input jack at the bottom of the base station; socket • the power socket on the wall. Power 2 Connect each end of the line cord to: adapter...
Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Select your country, then press [OK] to confirm. 4 Set the date and time. • If the time is in 12-hour format, press [PM].
Charge your phone Charge 8 hours Place the handset on the base station to charge the handset. When the handset is placed correctly on the base station, you hear a docking sound. » The handset starts charging. Note Charge the batteries for 8 hours before first use. Check the battery level When the handset is off the base station/charger, the bars indicate the battery level (full, medium and low).
Charge your mobile phone base station 1 For iPhone users, connect the plug of your USB charging cable (not supplied) to the USB socket at the bottom of SE888. Telephone 2 For mobile phones with micro USB charging, connect the micro USB cable plug to the micro USB socket of the mobile phone.
• If the name of SE888 exists in your mobile phone, you have to remove it from your mobile phone. Then you can do the pairing again. For PC pairing and PC phonebook download, install the PC software ‘ThinkLink’ saved in the cd rom or at http://www.philips.com/support...
Page 8
Enjoy Call Quick call from land line Press on the handset or and dial the phone number. Dial before you call 1 Dial the phone number on the handset or base station. 2 Press / to select the land line or Bluetooth line ( / / ) from which you want to make an outgoing call.
Answer a call • When there is an incoming call from the land line, press on the handset or • When there is an incoming call from the Bluetooth line, press on the handset or station. • When there are incoming calls from the land line and Bluetooth line at the same time, press / on the handset/base station to select a call, then, • on the handset, press...
Record an announcement 1 Press [Menu] 2 Select > [Announcement], then press [OK] to confirm. 3 Select [Answer & rec.] or [Answer only], then press [OK] to confirm. 4 Select [Record new], then press [OK] to confirm. 5 Start recording close to the microphone after the beep. 6 Press [OK] to stop recording.
Page 11
Listen to messages recorded on the answering machine Switch on/off the answering machine: Press Start/Stop listening to the recorded messages: Press Adjust the volume: Press Delete the current message: Press . Note For more information, see the Telephone answering machine section in the user manual.