Table of Contents
Advertisement
Available languages
Available languages
EngliSh
22
Question
Why does the charging
time of the parent unit
exceed 8 hours?
The specified operating
range of the baby
monitor is 100 feet/330
meters. Why does my
baby monitor manage a
much smaller distance
than that?
Why is the
connection lost every
now and then? Why are
there sound
interruptions?
What happens during a
power failure?
Is my baby monitor
secure from
eavesdropping and
interference?
The operating time of
the parent unit is
supposed to be at
least 24 hours. Why is
the operating time of
my parent unit shorter?
Answer
You may have set a maximum room temperature that is lower than
the actual room temperature or a minimum room temperature that is
higher than the actual room temperature. The baby unit continues to
send data to the parent unit and therefore uses more power.This
causes the non-rechargeable batteries of the baby unit to run low
quickly.
Perhaps you have switched on the nightlight. If you want to use the
nightlight, we advise you to run the baby unit on electrical power.
The parent unit may be switched on during charging. Switch off the
parent unit during charging.
The specified range is only valid outdoors in open air. Inside your
house, the operating range is limited by the number and type of walls
and/or ceilings in between. Inside the house, the operating range is up
to 150 feet/50 meters.
The ECO mode is switched on. When you operate the baby unit in
ECO mode, the operating range is 800 feet/260 meters in open air.
Inside your house, the operating range is limited by the number and
type of walls and/or ceilings in between. Move the parent unit closer to
the baby unit or switch off the ECO mode.
The baby unit and the parent unit are probably close to the outer
limits of the operating range. Try a different location or decrease the
distance between the units. Please note that it takes about 30 seconds
each time before a connection between the units is established.
If the parent unit is sufficiently charged, it continues to operate during a
power failure, both inside and outside the charger. If there are batteries
in the baby unit, it also continues to operate during a power failure.
The DECT technology of this baby monitor guarantees no interference
from other equipment and no eavesdropping.
When the parent unit has been charged for the first time, the
operating time is less than 24 hours. The rechargeable battery pack
only reaches its full capacity after you have charged and discharged it at
least four times.
The volume of the parent unit may be set too high, which causes the
parent unit to consume a lot of energy. Decrease the volume of the
parent unit
Advertisement
Table of Contents
