Prepare The Remote Control - Philips DS9800W/37 User Manual

»
has been set up for DS9800W, the
LED indicator starts to blink green
slowly.
To switch the unit to standby mode, press .
To switch the unit on from standby mode,
press again.

Prepare the remote control

Caution
Risk of explosion! Keep batteries away from heat,
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
12 EN
Note
Before pressing any function button on the remote
control instead of the main unit.
If you are not going to use the remote control for a
long time, remove the battery.