Garmin GPSMAP 696 Owner's Manual page 234

Appendix D
NOTE: If the GDL 39 RxB (white/orange wire) is not needed in a serial-pass
through installation, it should be grounded.
PIN # Direction
1 IN
6
10 IN
11 OUT
12 IN
13 IN
14 OUT
tis-A i
nterfAce
Configuring TIS-A input:
1) Press the MENU Key twice to select the Main Menu.
2) Turn or move the FMS Joystick to select 'System Setup', and press the ENT
Key.
3) Turn or move the FMS Joystick to select 'Interface', and press the ENT Key.
4) With the 'Serial Data Format' field highlighted, turn the FMS Joystick to
select 'TIS-A In'
The TIS-A Status field indicates one of the following messages:
• Waiting For Data—searching for a valid TIS-A data stream.
• Data Available—receiving TIS-A data from the transponder.
• Data Unavailable—connection to transponder established, but TIS-A service is
unavailable.
• Lost Connection—an error occurred or the connection to the transponder was
lost.
218
Description
Voltage Supply Input
Serial RxA (GDL39 IN)
Serial TxA (GDL39 OUT)
Discrete Input
Serial RxB (GDL39 IN)
Serial TxB (GDL39 OUT)
GDL 39 Bare Wire Cable Pinout (18Pin)
s
etUp
or GTX TIS-A In/NMEA & VHF Out
Garmin GPSMAP 695/696 Owner's Manual
GND
.
Wire Color
Red
Black
White/Green
Green
Gray
White/Orange
Orange
190-00919-00 Rev. G