Table of Contents
Advertisement
Assigning a NMEA 2000 Temperature Source
To use the GST 10 adapter, you must select the source for the temperature data.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
•
For most Garmin chartplotters, select
•
For other Garmin marine devices, select
3. Select the location of the temperature sensor.
Configuring the Temperature Offset
If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same
as temperature data displayed on other devices, you can configure the temperature offset to
increase or decrease the displayed temperature by a specific amount.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
•
For most Garmin chartplotters, select
•
For other Garmin marine devices, select
3. Select the temperature offset as a positive or negative decimal number, in degrees.
4. Select Done.
Troubleshooting the Sensor Number
If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source,
each adapter is assigned a unique sensor number automatically. If the "Invalid NMEA 2000
temperature configuration" error message appears, you must assign a unique sensor number to
each adapter.
For example, if two adapters are assigned the NMEA 2000 temperature source value of Live
Well and the error message appears, you must assign each adapter a unique number.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
•
For most Garmin chartplotters, select
•
For other Garmin marine devices, select
3. Select a sensor number.
4. Select OK.
Review
>
N2K Temp.
Config
>
N2K Temp.
Review
>
Temperature
Config
>
Temperature
Review
>
Sensor
Number.
Config
>
Sensor
GST 10 Installation and Configuration Instructions
Source.
Source.
Offset.
Offset.
Number.
Advertisement
Table of Contents
