Garmin GET 10, Engine Tilt Adapter Installation and Configuration Installation And Configuration Manual page 4

➋
Connecting the GET 10 Adapter to an
Existing NMEA 2000 Network
Configuring the GET 10 Adapter
note: This section provides specific configuration information for the GET 10 adapter using
your compatible Garmin display device. To access the NMEA 2000 configuration menu on your
display device, consult the documentation provided with your display device.
Calibrating the Engine Tilt
To use the GET 10 adapter, you must calibrate the tilt of the engine with which the adapter is
associated.
1. Turn the boat ignition key to the On position (not Start).
2. From the NMEA 2000 Devices list, select the GET 10 device.
3. Select an option:
• For most Garmin chartplotters, select
• For other Garmin marine devices, select
4. Follow the on-screen instructions to calibrate the engine tilt.
5. Select OK when the calibration is complete.
Configuring the Engine Number
If your boat has multiple engines, you can indicate which engine each GET 10 adapter is
associated with.
1. From the NMEA 2000 Devices list, select the GET 10 device.
2. Select an option:
• For most Garmin chartplotters, select
• For other Garmin marine devices, select
3. Select the number of the engine that the adapter is associated with.
4. Select Done.

➊
➋
➌
➍
➎
➊
GET 10 adapter
➋
NMEA 000 device (not included)
➌
Drop cable (optional - not included)
➍
T-connector (one included)
➎
Existing NMEA 000 network
Review > Engine Tilt
Config > Engine Tilt
Review > Engine Number.
Config > Engine
GET 10 Installation and Configuration Instructions
Calibration.
Calibration.
Number.