Print A Network Status Sheet; Printing And Copying Problems - Epson XP-600 Quick Manual

Cannot Scan Over the Network
■
EPSON Scan is not installed in Mac OS X 10.6 or 10.7; see page 18 for scanning and
download instructions.
■
If you cannot scan from the product's touch panel, make sure you restarted your
computer after installing the product software. Make sure EPSON Event Manager is
not being blocked by your firewall or security software. Try turning off the firewall.
■
If you are scanning a large document at high resolution, a communication error may
occur. If the scan did not complete, lower the scan resolution.
■
If network communication was interrupted while starting EPSON Scan, exit EPSON
Scan and restart it after a few seconds. If EPSON Scan cannot restart, turn the
product off and on, and then try again. Check the
. For details, see the EPSON Scan Help.
Settings
■
Make sure EPSON Event Manager is set up to communicate with your product.

Print a Network Status Sheet

1. Press
2. Press u or d to select
3. Press u or d to select
4. Press x twice to print the status sheet.

Printing and Copying Problems

■
When loading paper in the paper cassettes, make sure it is loaded facedown (usually
the whiter, brighter, or glossy side) and under the edge guides.
■
Make sure the paper size and source selected on the touch panel or in your printer
software is correct for the paper you loaded.
■
When scanning, position your original with the bottom against the front right corner
of the scanner glass. If the edges are cropped, move it away from the corner slightly.
■
You cannot print or copy when an ink cartridge is expended. Replace any expended
cartridges before printing.
■
To select two-sided printing in Mac OS X, choose
menu. Do not select
28
Solving Problems
if necessary, press l or r to select
Wi-Fi/Network Settings
Wi-Fi Status
Layout
Setup
, then press
, then press
OK
from the pop-up menu.
in
Timeout Setting
, then press .
OK
.
OK
.
from the pop-up
2-sided Settings
EPSON Scan