Replacing The Lamp; Closing The Door - Electrolux ENF4453AOX User Manual

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low/too high.
The temperature in
the refrigerator is too
high.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature dis-
play.
DEMO appears on
the Display.

REPLACING THE LAMP

CAUTION!
1
2

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
Possible cause
The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor.
The temperature regulator
is not set correctly.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
An error has occurred in
measuring the temperature.
The appliance is in demon-
stration mode (DEMO).
Disconnect the plug from the mains socket.
1.
2.
3.
4.
5.
3.
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that there
is cold air circulation.
Call your service representa-
tive (the cooling system will
continue to keep food prod-
ucts cold, but temperature
adjustment will not be possi-
ble).
Keep pressed approximately
10 sec. the Mode button
since a long sound of buzzer
is heard and the Display
shut off for a short while: ap-
pliance start works regularly.
Press on the rear hook of the lamp
cover by a screwdriver and at the
same time pull and rotate the cover in
the direction of the arrow.
Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cov-
er).
Fix the lamp cover into its original posi-
tion.
Connect the plug to the mains socket.
Open the door. Make sure that the
light comes on.
If necessary, replace the defective door
gaskets. Contact the Service Center.
ENGLISH 17