Replacing The Lamp; Closing The Door - Electrolux ENN2853AOW User Manual

14 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is too
high.
The temperature in
the freezer is too
high.

REPLACING THE LAMP

1

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Possible cause
The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature is
too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
2
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that there
is cold air circulation.
1. Switch off the appliance.
2. Press on the rear hook and at the
same time slide the cover in the direc-
tion of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the lamp cover).
4. Slide the lamp cover into its original
position.
5.
Switch on the appliance.
6. Open the door. Make sure that the
light comes on.