Asus WL-500gP V2 User Manual page 53

Problem
If the ADSL "LINK" light
blinks continuously or
stays off, Internet access
is not possible - the Router
is unable to establish a
connection with the ADSL
network.
Network name or encryption
keys are forgotten
How to restore the system
to its default settings
Chapter : Troubleshooting
• Ensure that all your cables are all properly
connected .
• Disconnect the power cord from the ADSL
or cable modem, wait a few minutes, then
reconnect the cord.
• If the ADSL light continues to blink or stays
OFF, contact your ADSL service provider.
• Try setting up the wired connection and
configuring the wireless encryption again.
• Press the Restore button at the rear panel
of the wireless router for more than five
seconds.
• Press the Restore button at the rear panel
of the wireless router for more than five
seconds.
• Refer to the section Firmware Restoration
in Chapter 5 of this user manual.
The following are the factory default settings:
User Name: admin
Password: admin
Enable DHCP: Yes (if WAN cable is plugged in)
IP address: 19.18.1.1
Domain Name: (Blank)
Subnet Mask: 55.55.55.0
DNS Server 1: 19.18.1.1
DNS Server 2: (Blank)
SSID: default
Action
WL-500gP V
53