Removing The Stand; Installing A Wall-Mount Bracket; Tv Components; Front And Side Controls - Dynex DX-55L150A11 User Manual

4
DX-55L150A11
3 Align the base with the TV, then secure the stand to the TV with
the six screws (M6 x 12) provided.
4 Carefully lift the TV into an upright position.
To remove the stand, see the following procedure.

Removing the stand

You must remove the stand before you can wall-mount the TV.
Note: Your TV may differ from the illustrations shown.
To remove the stand:
1 Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
2 Remove the six screws holding the stand to the TV, then remove
the stand.

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand, if it has been installed.
Warning: These instructions are for use by qualified service person only.
To reduce the risk of hazards, do not perform any servicing other than
that contained in the operating instructions unless you are qualified to
do so.
To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the pedestal stand. See "Removing the stand" above.
Baseplate
3 Secure the wall-mount bracket to the back of your TV using the
four screws provided with the bracket.

TV components

Front and side controls

Item Name Description
MENU Press to open the on-screen menu.
1
INPUT Press to open the INPUT SOURCE menu.
2 For more information, see "Selecting the
video input source" on page 11.
In TV mode, press to increase or decrease
VOL / VOL
the volume.
3
In menu mode, press to move right or left or
to adjust menu settings.
In TV mode, press to select the next or
CH /CH
previous channel.
4
In menu mode, press to move up or down.
Press to turn on the TV or put the TV in
(power)
standby mode.
5
Caution: The TV continues to receive power
even in standby mode. Unplug the power
cord to disconnect power.
Power indicator Lights red when your TV is in standby mode.
6
Turns off when the TV is on.
Remote control Receives signals from the remote control.
7 sensor Do not block. For more information, see
"Aiming the remote control" on page 7.
TV components