Installing And Removing The Stand; Installing The Stand; Installing A Wall-Mount Bracket - Dynex DX-32L150A11 User Manual

4
DX-32L/37L/40L/46L
Installing and removing the
stand
You must install your TV into the stand in order for it to stand upright
on a cabinet or other flat surface. If you intend to mount your TV on a
wall or other vertical surface, you must remove the stand column.
Cautions
• Read these instructions carefully before you try to assemble the
stand or remove the stand column.
• Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability
to do this, contact a professional installer or service technician.
Dynex is not responsible for any damages or injuries that occur
because of mishandling or incorrect assembly.
• Use a soft cushion or covering to prevent scratching or damage to
the TV screen or cabinet.
• The speaker is not intended to support the weight of the TV. Do
not move or handle the TV by the speaker. This can cause
damage that is not covered by your warranty.
• Before assembly or removal of the stand, unplug the power cord.

Installing the stand

Note: Your TV may differ from the illustrations shown.
To install the stand:
1 Remove the stand from the box .
Note: The wide portion of the stand should face the front of the
TV.
2 Lay the TV (screen down) on a flat, cushioned surface.
3 Align the stand with the TV, as shown in the following
illustration.
Stand
Locators
Locating grooves
Four M5 screws

Installing and removing the stand

Locators
Stand
4 Move the stand gently until the locating ridges on the stand
column align with the locating grooves on the stand.
5 Align the holes in the stand with the holes in the stand column,
then secure the stand to the column with the four M5 screws
provided.
To remove the stand, loosen the four screws.

Installing a wall-mount bracket

To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the four screws that secure the TV to the base.
3 Remove the four screws holding the stand column to the TV,
then remove the stand column.
Stand column
Note: The appearance of the TVs in these illustrations may differ from
your actual TV and are for instructional purposes only.
4 Secure the wall-mount bracket to the back of your TV using the
four M6 screws provided with the bracket.
Locating
grooves
Four M5 screws
Remove four
screws
Remove the stand
column