Asko T793 Operating Instructions Manual page 26

Installation instructions
C. Built-in
ASKO dryers can be installed beneath a
cabinet or worktop with a minimum height of
34" (864 mm). There must be a gap of about
1/2" (12 mm) all around the machine, includ-
ing between the rear edge of the machine top
panel and the back wall. The opening width
must be at least 24-1/2" (622 mm). The con-
densing models work best when they have
good air circulation. Install the dryer so the
condensed water will continuously flow into
a drain or sink, you will need a drain outlet
behind the unit. The maximum drain height is
40" (1016 mm).
Notes
The height adjustment for the dryer is 33-1/2"
to 34-1/2" (850 mm to 876 mm). Do not raise
it higher than 34-1/2" (876 mm). Hole measure-
ments are from center of hole.
26 Customer Care Center
1-800-898-1879
www.askousa.com