Dell D630 - LATITUDE ATG NOTEBOOK User Manual page 111

D
R I V E N O T R E A D Y
continue. Install a hard drive in the hard drive bay (see "Drive Problems" on
page 106).
E PCMCIA
R R O R R E A D I N G
Reinsert the card or try another PC Card (see "Installing a PC Card or
ExpressCard" on page 82).
E
X T E N D E D M E M O R Y S I Z E H A S C H A N G E D
NVRAM does not match the memory installed in the computer. Restart the
computer. If the error appears again, contact Dell (see "Obtaining Assistance"
on page 193).
T
H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
that you are trying to copy is too large to fit on the disk, or the disk is too full.
Try copying the file to a different disk or use a larger capacity disk.
A
F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
Do not use these characters in filenames.
> | —
G A 2 0
A T E F A I L U R E
modules and, if necessary, replace them (see "Memory Problems" on page 119).
G
E N E R A L F A I L U R E
The message is usually followed by specific information—for example,
Printer out of paper. Take the appropriate action.
H -
A R D D I S K D R I V E C O N F I G U R A T I O N E R R O R
drive type. Shut down the computer, remove the hard drive (see "Hard drive
problems" on page 108), and boot the computer from media. Then shut down
the computer, reinstall the hard drive, and restart the computer. Run the Hard-
Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 101).
H -
A R D D I S K D R I V E C O N T R O L L E R F A I L U R E
commands from the computer. Shut down the computer, remove the hard drive
(see "Hard drive problems" on page 108), and boot the computer from media.
Then shut down the computer, reinstall the hard drive, and restart the
computer. If the problem persists, try another drive. Run the Hard-Disk Drive
tests in the Dell Diagnostics (see "Dell Diagnostics" on page 101).
H -
A R D D I S K D R I V E F A I L U R E
from the computer. Shut down the computer, remove the hard drive (see "Hard
drive problems" on page 108), and boot the computer from media. Then shut
The operation requires a hard drive in the bay before it can
—
—
C A R D
A memory module may be loose. Reinstall the memory
—
The operating system is unable to carry out the command.
—
The hard drive does not respond to commands
—
The computer cannot identify the PC Card.
The amount of memory recorded in
—
The computer cannot identify the
—
The hard drive does not respond to
0 —
The file
—
: \ / : * ? " <
Troubleshooting
111